Test article performance against test program objectives and specification requirements is presented. Since your colors are everywhere, clearly it doesn't follow any rules. It is part 32-8248 It has 2-white 2-Black 2 yellow 2-Red 2 yellow 1-green 1- brown and 2- Blue wires. I have a Philco power transformer that is confusing. In addition output tube plate was a blue wire and B+ in general red. The sodium flow servo loop, consisting of a flow controller, the drive and speed control system, the pump and hydraulic loop with a Permanent Magnet flowmeter were tested for sinusoidal, step and ramp responses. Red is usually HT, black primary, gray might be a tertiary heater, brown could be primary, heater or ground (CT), yellow for rectifier filament. These colors were used on power transformers and radio wiring.
Sinusoid, step, and ramp responses of the Drive System were tested Drive gain margin and phase margin were determined for both closed loop and open loop conditions. Drive speed control servo testing was accomplished using the pump and hydraulic test loop as a load. Shaft seal heat exchanger performance with the sodium fluid as high as 1100F was more » validated. Pump performance testing included hydraulic performance in sodium at pony motor and main motor speeds, cavitation testing, gaseous cellular convection testing, fluid thermal transients tests and endurance testing. USE COUPON CODE: FLIP25YEARS TO GET 10 OFF OFDERS OVER 125.00. The document describes the test articles, describes the test planning documents, the test facilities, the data acquisition system, and presents the test results with observations/conclusions. FLIPTOPS 25TH ANNIVERSARY 10 OFF SALE ON ORDERS OVER 125.00. This document reports the results of qualification testing the Clinch River Breeder Reactor Plant Prototype Sodium Pump, Drive System and Flow Controller at the Energy Technology Engineering Center`s Sodium Pump Test Facility.
0 kommentar(er)
